HGV Trailer Haldex EB+Gen3 EBS/ABS controller

haldex eb+ gen 3 rebuild

Fitted to a massive range of HGV trailers between the years 2013 – 2021 the Haldex EB+Gen3 EBS/ABS unit is very problematic when it fails. Common internal malfunction of the Haldex controller unit will cause the constant illumination of the ABS warning light.

 

When running diagnostics fault codes may be found for Modulator Pressure Sensor 2.1 or 2.2 which often cannot be deleted and will prevent full operation of the emergency braking system. These units also suffer from a manufacturing defect that will cause an air leak into the EBS/ABS unit.

 

Up until now the only way around this was to purchase a brand new, and very expensive, replacement, or fit a second hand one. However all Haldex EB+Gen3 units are inherently faulty and you will be left in the same situation again in no time, but with a lighter wallet.

 

We have a far better solution – a rebuild of your original unit with an unlimited mile Lifetime Warranty within 1-2 working days. Our R&D team have delved deep into these Haldex controllers and identified all commonly failing components and manufacturing defects, meaning we can fully rebuild your unit working out all original flaws to ensure full operation always.

 

Shop Now

 

Common Failure symptoms:

  • Constant ABS light illumination
  • No emergency braking assistance
  • Air leak from the ABS/EBS unit

 

Common fault codes:

  • Modulator Pressure Sensor 2.1
  • Modulator Pressure Sensor 2.2

 

Affected Vehicles:

  • These units are fitted to a wide variety of HGV Trailers 2013 - 2021

 

Common failing part numbers:

(Can’t find your part number? Check our full EBS/ABS catalogue for HGV Trailers)

 

Test and rebuild:

Each EBS/ABS unit is fully tested by our technicians both before and after rebuild to ensure no faults return. All common failing components are replaced with versions that are higher rated than standard, so you can be assured that once your unit has been rebuilt it will perform as good as, if not better than a brand-new unit from the manufacturer.

 

Programming:

All programming remains intact whilst we test and rebuild the EBS/ABS unit.

 

Quality:

Our strict quality control comprises of testing, workmanship, components and ESD safety which ensures only the highest level of work is carried out to meet our lifetime warranty standards. We work very closely with dealerships and specialists, offering a better, more reliable and cost-effective solution to replacement. Our work defect rate is lower than 0.49% on all our rebuilds, so you can be assured of our very high standard of work.

Warranty:

Lifetime unlimited mileage*

 

How do I get my unit rebuilt?

To pay for the rebuild select you part number above and then click: Get yours rebuilt

Print the payment/booking confirmation email.

Package the Haldex EB+Gen3 unit inside a sturdy box with plenty of packaging material (make sure you include your confirmation email in the box).

Send us your package by tracked courier (the shipping instructions are on the confirmation email).

Once received we will test, rebuild and return your EBS/ABS with an unlimited mileage lifetime warranty. (if your unit turns out not to be faulty then we will refund your payment less a small testing fee and return shipping)

 

What if I don’t want to pay up front?

This is not a problem, if you prefer this option then follow the following steps:

Fill in and submit this test form.

Print the booking confirmation email.

Package the Haldex controller inside a sturdy box with plenty of packaging material (make sure you include your confirmation email in the box).

Send us your package by tracked courier (the shipping instructions are on the confirmation email).

Once received, we will test your unit and call you to advise on the outcome of testing, if your unit is faulty and you choose to go ahead with the rebuild then we will take payment over the phone using a debit/credit card.

We will then rebuild your EBS/ABS and return it to you with an unlimited mileage warranty.

If you require further information regarding this Haldex EB+Gen3 EBS/ABS unit then please contact us.

HGV Products/Services

Comments on "HGV Trailer Haldex EB+Gen3 EBS/ABS controller"
Darren kelly says: 2/8/2021 8:28:27 PM
Was starting price for this
ECU Admin says: 3/8/2021 9:17:36 AM
Hi Darren, for prices and shipping information please select your unit from the following list: https://www.ecutesting.com/product-catalogue/hgv/trailer/electronic-braking-system/
Leave a Comment All fields are required*