Saab Throttle Body 95 & 93

Saab throttle body faults

SAAB Throttle Body Failure

 

The throttle body in SAAB 9-3 and 9-5 models commonly faces failure, internal malfunction of components within the throttle body will cause an array of performance issues such as poor starting of the engine, rough idle, and power loss.

 

Throttle body problems are indicated by an illuminated engine management light, and often the throttle body will receive little to no throttle response, which will force the vehicle into limp mode.

 

If the vehicle is scanned with diagnostic equipment the most common stored fault codes you will find are related to throttle valve issues including:

 

 

  • P1230 - Throttle Valve / Pedal Position Sensor Signal Not In Range
  • P1251 - Throttle Valve Control Motor Stuck Open / Position Fully Closed
  • P1231 - Throttle Valve Control Signal Not In Range
  • P1261 - Throttle Valve Malfunction

 

Solution

Because throttle bodies are an essential component of the SAAB engine’s air intake system, when they fail they will cause a wide range of performance issues such as rough idle, lack of power, and poor starting.

Currently there are no remanufacturing solutions for this throttle body. However, an alternative is available through buying a replacement unit, which are available from specialists such as Neo Brothers here: https://www.neobrothers.co.uk/car-parts/engine/air-supply/throttle-body

 

Common Failure symptoms:

  • Engine management light
  • Poor idle
  • Poor cold start
  • Rough running / power loss
  • Limp mode

 

Common fault codes:

  • P1230 - Throttle Valve / Pedal Position Sensor Signal Not In Range
  • P1251 - Throttle Valve Control Motor Stuck Open / Position Fully Closed
  • P1231 - Throttle Valve Control Signal Not In Range
  • P1261 - Throttle Valve Malfunction

 

Affected Vehicles:

Saab 9-3 1993-2003

Saab 9-5 1997-2010

 

Common failing part numbers:

00761600

00761600

007623191

Saab Products/Services

Comments on "Saab Throttle Body 95 & 93"
Leave a Comment All fields are required*