Mazda 3 ABS Pump Module fault
Fault code: “C1288 PRESSURE TRANSDUCER MAIN/PRIMARY CIRCUIT FAILURE”
This ABS Pump Module is a very common failure for the Mazda 3 built between 2004 - 2008. The fault causes the ESP light to illuminate permanently on the instrument cluster.
If you have been for a diagnostic check on your Mazda 3 then your mechanic will probably have told you that your have a fault with your “Brake Pressure sensor” or given you the full fault code of: “C1288 PRESSURE TRANSDUCER MAIN/PRIMARY CIRCUIT FAILURE” and will probably have told you that you must change your ABS Pump Module for a small fortune
The main dealer is currently charging over one thousand pounds plus fitting for a replacement ABS pump module. We can rebuild your own ABS pump module to a new specification for £250 and provide an unlimited milage Lifetime Warranty*.
When we rebuild your ABS pump we not only correct the problem but the materials and processes we use will reinforce your ABS pump module to prevent the fault from ever reoccurring.
Common Failing Part Numbers:
|
3M51-2C405-HA
|
|
10.0960-0115.3
|
|
10.0206-0172.4
|
|
 |
(This is just a small list of common part numbers, we cover the entire range of ATE MK60 ABS ASC Pump modules).
We will need your ABS Pump for approximately 2 - 3 working days to complete the full rebuild (times may vary depending on current workload & demand). If you would like to arrange for your ABS Pump to be tested and rebuilt then please fill in this test form.
For further advice please contact us.
!!SAFETY WARNING!!
We DO NOT modify your braking system in any way or install any kind of additional wires, pipes or sensors to your ABS unit. These ABS units are highly advanced & sensitive Anti-locking Braking Systems and are vital for your own safety so should NEVER ever be modified in any way whatsoever. When we rebuild your ABS unit we do not change the design or function of your ABS Pump Module - your ABS system will be returned to you functioning and looking exactly as it was originally designed.